產品介紹:
R1210NXX2C/XX2D系列為PWM升壓DC/DC變換器控制器,精度高,CMOS工藝低電流。
R1210NXX2X系列的每一個都由振蕩器、PWM電路、參考電壓單元、誤差放大器、相位補償電路、電壓檢測電阻、芯片使能電路、抗劇烈負載暫態控制器和輸出電壓檢測器組成。一個低紋波,高效率的升壓DC/DC變換器可以由這種集成電路組成,只需要四個外部組件,或一個電感,一個二極管,一個晶體管和一個電容。
R1210NXX2X系列可通過電路控制器檢測輸出電壓的急劇變化,提高了負載的瞬態響應。
每個R1210NXX2X系列都有一個驅動引腳,或外部晶體管的“EXT”引腳。通過將一個低通電阻的功率電阻電阻電阻連接到EXT'引腳,大電流通過電感,從而可以提供大輸出電流。
內置芯片使能電路,以超低靜電流實現待機。
由于這些集成電路的封裝是小型SOT-23-5,因此可以在板上高密度安裝集成電路。
產品特性:
外部組件……
只有電感、二極管、電容和晶體管
當前……TYP備用。OuA
低的輸出電壓溫度漂移系數....TYP.±100ppm/C
輸出電壓 ...........在2.2V到6.0 v范圍內,步長0.1V進行逐級設置
兩種基本振蕩器頻率......的選擇100千赫(XX2C), 180千赫(XX2D)
小包裝……OT-23-5 (Mini-mold)
低波紋,低噪聲
振蕩器的啟動電壓 .....................MAX.0.8v
應用程序
電池供電設備的電源。
便攜式通訊設備,照相機,錄像機的電源
要求電壓高于電池電壓的電器的電源。
更多推薦:
R1210N221A,R1210N231A,R1210N241A,R1210N251A,R1210N261A,R1210N271A,R1210N281A,R1210N291A,R1210N301A,R1210N311A,R1210N321A,R1210N331A,R1210N341A,R1210N351A,R1210N221C,R1210N231C,R1210N241C,R1210N251C,R1210N261C,R1210N271C,R1210N281C,R1210N291C,R1210N301C,R1210N311C,R1210N321C,R1210N331C,R1210N341C,R1210N351C,R1210N361C,R1210N371C,R1210N381C,R1210N391C,R1210N401C,R1210N411C,R1210N421C,R1210N431C,R1210N441C,R1210N451C,R1210N461C,R1210N471C,R1210N481C,R1210N491C,R1210N501C,R1210N511C,R1210N521C,R1210N531C,R1210N541C,R1210N551C,R1210N561C,R1210N571C,R1210N581C,R1210N591C,R1210N601C,R1210N221D,R1210N231D,R1210N241D,R1210N251D,R1210N261D,R1210N271D,R1210N281D,R1210N291D,R1210N301D,R1210N311D,R1210N321D,R1210N331D,R1210N341D,R1210N351D,R1210N361D,R1210N371D,R1210N381D,R1210N391D,R1210N401D,R1210N411D,R1210N421D,R1210N431D,R1210N441D,R1210N451D,R1210N461D,R1210N471D,R1210N481D,R1210N491D,R1210N501D,R1210N511D,R1210N521D,R1210N531D,R1210N541D,R1210N551D,R1210N561D,R1210N571D,R1210N581D,R1210N591D,R1210N601D,R1210N222C,R1210N232C,R1210N242C,R1210N252C,R1210N262C,R1210N272C,R1210N282C,R1210N292C,R1210N302C,R1210N312C,R1210N322C,R1210N332C,R1210N342C,R1210N352C,R1210N362C,R1210N372C,R1210N382C,R1210N392C,R1210N402C,R1210N412C,R1210N422C,R1210N432C,R1210N442C,R1210N452C,R1210N462C,R1210N472C,R1210N482C,R1210N492C,R1210N502C,R1210N512C,R1210N522C,R1210N532C,R1210N542C,R1210N552C,R1210N562C,R1210N572C,R1210N582C,R1210N592C,R1210N602C,R1210N222D,R1210N232D,R1210N242D,R1210N252D,R1210N262D,R1210N272D,R1210N282D,R1210N292D,R1210N302D,R1210N312D,R1210N322D,R1210N332D,R1210N342D,R1210N352D,R1210N362D,R1210N372D,R1210N382D,R1210N392D,R1210N402D,R1210N412D,R1210N422D,R1210N432D,R1210N442D,R1210N452D,R1210N462D,R1210N472D,R1210N482D,R1210N492D,R1210N502D,R1210N512D,R1210N522D,R1210N532D,R1210N542D,R1210N552D,R1210N562D,R1210N572D,R1210N582D,R1210N592D,R1210N602D
OUTLINE
The R1210NXX2C/XX2D Series are PWM step-up DC/DC Converter controllers, with high accuracy, low supplycurrent by CMOS process.
Each of the R1210NXX2X Series consists of an oscillator, a PWM circuit, a reference voltage unit, an error ampli-fier, phase compensation circuit, resistors for voltage detection, a chip enable circuit, a controller against drastic loadtransient and an output voltage detector. A low ripple, high efficiency step-up DC/DC converter can be composed ofthis IC with only four external components, or an inductor, a diode, a transistor and a capacitor.
The R1210NXX2X Series can detect drastic change of output voltage with a circuit controller, the load transient re-sponse is improved.
Each of the R1210NXX2X Series has a driver pin, or 'EXT' pin for external transistor. By connecting a power ran-sistor with low ON-resistance to EXT' pin, a large current flows through an inductor thus, large output current can besupplied.
The built-in chip enable circuit can make the standby mode with ultra low quiescent current.
Since the package for these ICs is small SOT-23-5, high density mounting of the ICs on board is possible.
FEATURES
External Components ...…
Only an inductor, a diode, a capacitor, and a transistor
Standby Current .......TYP. OuA
Low 'Temperature-Drift Coefficient of Output Voltage....TYP.±100ppm/C
Output Voltage ...........Stepwise Setting with a step of 0.1V in the range of 2.2V to6.0V
Two choices of Basic Oscillator Frequency......100kHz (XX2C),180kHz(XX2D)
Small Package.......OT-23-5(Mini-mold)
Low Ripple, Low Noise
Oscillator Start-up Voltage..................... MAX.0.8v
APPLICATIONS
Power source for battery-powered equipment.
Power source for portable communication appliances, cameras,VCRs
Power source for appliances which require higher voltage than battery voltage.